TRAXXAS MAXX Front Steering Blocks 7075-T6 TXMS021N by GPM  [TXMS021N]

7075-T6 aluminium steering knuckles for TRAXXAS MAXX

These aluminium front steering blocks are a direct replacement machined from 7075-T6 aluminium to reinforce the front knuckle area and give a metal alternative to the original plastic pieces. The profile is trimmed for a modern look while keeping the mounting pattern aligned with the TRAXXAS MAXX front knuckle locations.

Two separate tie-rod mounting holes let you move the steering link to alternate positions and alter the tie rod angle for on-car tuning of steering response and handling in RC setups. This adjustability is intended for model setup work only, not for real vehicles.

Installation notes: the kit includes the knuckle arms and the stainless steel mounting screws listed below, and these parts replace the factory front knuckles while using the existing steering linkage and hardware pattern. When installing, confirm screw torque and check clearances around the suspension and servo to prevent binding.

Use these aluminium front steering blocks when you want a robust metal option and quick tie-rod geometry changes on TRAXXAS MAXX 1/10 rigs; always verify fit before regular use.