TRAXXAS MAXX Adjustable Front and Rear CVD Drive Shafts TXMS3F/RSA/2 by GPM  [TXMS3F/RSA/2]

Adjustable front and rear CVD shafts for MAXX

This GPM TXMS3F/RSA/2 set is an RC-scale front and rear drive shaft upgrade made to fit the TRAXXAS MAXX MONSTER TRUCK. It replaces conventional cross-head half-shafts with CVD swing joints to provide steadier power delivery under load while keeping the assembly appropriate for hobby-grade models.

The assembly pairs hardened steel in the joint areas with 6061-T6 aluminum bodies to give a useful balance of strength and weight. The adjustable layout helps tune suspension geometry and reduces binding through travel, while the supplied screw pins secure the CVD pieces to existing axle interfaces.

Installation overview: this set is intended as a direct replacement on MAXX drivetrains where stock splines and pin locations match; installation requires removing the affected wheel hubs and drive assemblies and fitting the included pins to retain the CVD components. After fitting, rotate through suspension travel to confirm free movement and re-check fastener tightness for safe operation.

For MAXX owners wanting a robust, adjustable aftermarket driveline, this GPM CVD kit uses hardened contact surfaces and aluminum bodies to boost durability and reduce driveline binding under demanding use.