TRAXXAS MAXX Adjustable CVD Drive Shaft Set Hardened Joint 6061 T6 Aluminum TXMS123F/RSA by GPM  [TXMS123F/RSA]

Adjustable CVD shafts built for TRAXXAS MAXX

This aftermarket CVD drive shaft set is made for TRAXXAS MAXX monster truck drivetrains and carries the model TXMS123F/RSA. The assembly replaces the original cross-head half-shaft with a constant velocity swing joint to deliver a more direct torque path and to lower joint stress during heavy suspension movement.

The design pairs a hardened steel joint with a 6061 T6 aluminum body to balance strength and reduced mass. Each half-shaft is adjustable so you can fine-tune length and alignment to improve suspension geometry and minimise binding in long-travel setups. Use these parts only in model-scale drivetrains.

Installation notes: the shafts are suitable for front or rear positions and require removal of the wheel hex and access to the drivetrain for replacement. Confirm clearance against suspension links and bearing carriers before final installation, and inspect pins and joint surfaces after break-in runs.

This TXMS123F/RSA set provides a direct-replacement CVD option for TRAXXAS MAXX builders who want adjustability and a hardened joint for better driveline alignment and longevity.