TRAXXAS MAXX +20mm adjustable CVD with 7075-T6 hex adapter TXMS143F/RSN by GPM  [TXMS143F/RSN]

Adjustable CVD kit for widened MAXX setups

The kit replaces the stock cross-pin drives with adjustable CVD swing joints to improve power transfer on 1/10 TRAXXAS MAXX platforms. The assembly pairs a hardened steel joint with a 6061-T6 alloy body to keep the unit stiff while remaining reasonably light. The design ups the axle diameter from 6mm to 8mm to cope with the greater loads common to widened builds, while still allowing length adjustment for suspension tuning.

Supplied hardware includes 7075-T6 aluminum hex adapters and wheel locks sized for the thicker axle, and the package includes matching 8x16x5 bearings for the revised shaft dimensions. The components suit front or rear drive and wheel mounting and are intended for MAXX conversions that use +20mm widening kits.

For builders widening a TRAXXAS MAXX or fitting +20mm kits, this upgrade supplies thicker 8mm axles, hardened swing joints and 7075-T6 hex hardware to support heavier wheelloads and allow fine length adjustment at both front and rear.