TRAXXAS Latrax Rally 1/18 Long Lower-Arm Pins LTX055/PINS by GPM  [LTX055/PINS]

Long lower-arm pins for Latrax Rally upkeep

This aftermarket 4pcs pin set is specified for use with TRAXXAS 1/18 Latrax Rally LTX055 front and rear lower arms in the aluminum variant, providing a direct replacement for worn or damaged hinge pins. The item is intended as a simple spare or hop-up part to restore hinge fit and maintain suspension alignment on the model chassis.

Fit and function: these pins act as the pivot fastener between the lower arm and the chassis or suspension mount, so correct sizing is important to prevent excess play in the suspension. Check the pins against the existing lower arm before completing assembly and confirm smooth pivoting through the full suspension travel.

Installation notes: change pins one corner at a time to preserve wheel alignment, reuse the vehicle's original retainers or clips to secure each pin, and inspect nearby bushings or bearings while the arm is removed. Basic hand tools are adequate for removal and refit, and a short bench check after installation is advisable before the first run.

This 4pcs set is a straightforward spare for routine maintenance and tuning of a TRAXXAS Latrax Rally 1/18 fitted with LTX055 aluminum lower arms.