TRAXXAS Latrax Rally 1/18 23mm Steel Front and Rear CVD Shaft SLTX223 by GPM  [SLTX223]

Aftermarket 23mm CVD for Latrax Rally 1/18

This 23mm steel front and rear CVD is an aftermarket replacement for TRAXXAS Latrax Rally 1/18, supplied as part SLTX223. It replaces the standard polymer drives with a metal shaft intended to increase wear resistance while matching the stock geometry.

In service the shaft transmits torque from the gearbox outputs to the wheel hubs as a direct driveline member. Fitting follows common small-scale CVD procedures: remove the original driveshaft, check hub and gearbox mating faces, fit the steel CVD and retain with the original hardware. Inspect nearby 走珠軸承 and the hub hex for wear when the shaft is serviced.

The geometry is neutral to stock so no alignment changes are required; the metal shaft offers improved resistance to abrasion and impact compared to plastic, making it a sensible refresh for models used frequently on rough surfaces or in repeated practice sessions.