TRAXXAS FUNCO PRO SCALE 2WD SAND CAR Front and Rear Suspension Pins 4140 Carbon Steel TPS/PIN by GPM  [TPS/PIN]

4140 carbon pins to reduce suspension play

This TPS/PIN kit supplies ready-to-fit front and rear suspension pins made for the TRAXXAS FUNCO PRO SCALE 2WD SAND CAR. The set is offered as an aftermarket replacement to stabilise both front and rear suspension arms and to make disassembly and reassembly of the suspension quicker during routine service.

The pins are manufactured from imported medium carbon steel that has been hardened and given a black finish. The head profile uses an external hex for more secure tool engagement while installing or removing fasteners. Precision thread work helps minimise thread slippage and makes maintenance runs more consistent. The kit also includes the lock nuts and E-clips needed to secure each pin in place.

The kit supplies inner and outer pins for front and rear mounting positions, addressing typical wear points at the pivot locations on the 1/6 FUNCO PRO chassis. Follow normal RC maintenance procedures when fitting these pins and check thread direction and clip seating during assembly.

Install these pins where pivot wear or play appears, then re-check fastener torque after the first outing to confirm secure fitment and correct clip seating.