TRAXXAS Funco Pro Scale 2WD 32-Tooth Differential Gear TPS032TS by GPM  [TPS032TS]

32T hardened replacement for Funco Pro 1/6 sand drivetrains

This RC-scale replacement differential gear fits the TRAXXAS Funco Pro Scale 2WD sand car platform. The component is made from 20CrMnTi alloy steel, heat treated and blackened to increase surface hardness and wear resistance, and supplied as a single 32-tooth unit with module M1.5 to match factory dimensions. The part is intended as a direct service or upgraded substitute for the original factory gear.

In a 1/6 scale sand car drivetrain the differential gear transfers torque between the gearbox output and wheel axles while influencing backlash, mesh stability, and overall durability under abrasive conditions. Swapping a worn 32T gear for a hardened 20CrMnTi unit helps restore correct geometry and reduce wear during high-load sand running.

Use this hardened 32T unit when restoring factory gear geometry or when a tougher steel replacement is needed for sand use; always confirm fit with the listed compatible model before installation.