TRAXXAS Slash/Stampede/Rustler Rear Driveshaft 6mm Axle FR106R by GPM  [FR106R]

Rear CVD driveshaft for TRAXXAS 1/10 trucks

This RC-scale rear driveshaft assembly is designed for select TRAXXAS 1/10 models and is sold as FR106R. The unit pairs 6061 aluminium alloy components with medium carbon steel parts in a constant-velocity (CVD) layout to keep rotating mass low while improving drivetrain engagement compared with basic stamped or plastic shafts.

Fitment targets the rear drive shaft area and uses a 6 mm axle on the primary compatible models listed below. The CVD geometry helps maintain smoother power transfer under acceleration and during suspension articulation, giving a practical balance of durability and reduced drivetrain lash for Slash, Stampede, Rustler and Ford F-150 Raptor chassis variants.

Installation notes: replace the rear driveshaft assembly in the rear drive shaft area, verify the axle diameter on your chassis before fitting, and keep original screw pins and retaining hardware tight. Some TRAXXAS 4x4 variants listed below use 5 mm axles and require the #9080 upgrade kit to adapt this part.

For TRAXXAS owners wanting a stiffer rear shaft with lower rotating weight and crisper CVD action, the FR106R is a sensible aftermarket upgrade; confirm axle diameter before buying and fit the #9080 adapter where required.