TRAXXAS E-REVO Steering and Support Links Spring Steel ER162ST by GPM  [ER162ST]

Reinforced front and rear steering links

This 4-piece link set is an aftermarket steering and rear support upgrade for 1/10 TRAXXAS platforms like E-REVO, Summit, Revo and E-REVO 3.3. Fabricated from spring steel, the rods deliver higher tensile strength than thinner stock links and a beefier profile that resists bending during aggressive electric or nitro use.

Fitment and basic function: the kit replaces factory front steering tie rods and rear support links to reduce flex and tighten the mechanical connection between the steering knuckles and chassis. Threaded rod ends let you fine-tune toe and rear link length during setup.

Adjustment and thread note: the tie rods use a 4mm thread size that permits clockwise and anti-clockwise length adjustment, enabling small changes to toe-in/toe-out and chassis balance without cutting or re-threading.

Included hardware and basic contents: the package contains replacement links plus stainless steel screws for installation, listed below in the specifications section.

Choose these links when you need a stronger steering connection than stock rods provide and when threaded adjustment is required for precise setup on 1/10 TRAXXAS chassis.