This aluminium front lower suspension arm is a replacement component for TRAXXAS E-REVO and similar chassis. It is made to restore steering geometry and provide a stronger mounting point than the stock plastic arms, supplied as a one pair set for left and right front positions.
The arm plays a role in front-end tuning, influencing roll centre and camber response under load. Replace worn arms to recover handling predictability, and confirm hinge pin spacing and mounting hole alignment against your chassis before assembly.
Installation tips: reuse existing hinge pins when they match, or fit the correct size replacement pins; hand-tighten screws to seat the part then torque to recommended values to avoid thread damage; check that suspension travel is free after fitting. This item is intended for model RC use only.
Fit this aluminium front lower arm to replace broken stock parts or to add a durable option for front-end tuning on TRAXXAS E-REVO based models, then recheck alignment and geometry after installation.
Copyright © 2008-2026 rcjaz.ca All rights reserved