TRAXXAS E-REVO Front Drive Shaft Set Adjustable 75-80mm ER037SF by GPM  [ER037SF]

Front drive shafts for 1/10 TRAXXAS platforms

This 4 pcs front drive shaft set is an aftermarket replacement built for RC-scale TRAXXAS machines. Machined from steel #45, the shafts give a robust option for front driveline use on 1/10 E-REVO and Summit models while remaining intended for hobbyist applications. The assembly suits situations where driveline stability and reliable length adjustment are required.

Key mechanical details from the product notes: the shafts are adjustable between 75mm and 80mm to fit different steering and suspension setups, and steel retaining rings at both ends secure the pins. The layout supports routine driveline tuning, helps keep alignment under load, and fits common 1/10 scale front axles and hubs.

Supplied hardware as listed: 6x8x5 aluminium collar - 1 pcs, and 2.5xM4Tx15 screw pin - 2 pcs. Correct installation and periodic inspection of the retaining rings reduce the chance of pin migration during normal RC running.

For builders tuning front driveline geometry on TRAXXAS E-REVO and Summit 1/10 rigs, the ER037SF steel #45 4 pcs set is a direct, adjustable replacement that emphasizes durability and positive pin retention.