Traxxas E-Revo Front and Rear Stainless Steel 304 Turnbuckle Kit ER2162S/2 by GPM  [ER2162S/2]

E-Revo steering link upgrade

This turnbuckle set is an RC-scale steering linkage made for the Traxxas E-Revo 56087-1 platform, providing adjustable front and rear connection points between steering knuckles and tie rods. Built from stainless steel 304, the components resist corrosion and give a firmer threaded joint than typical plated alloys found in basic linkages.

The parts let you trim toe and steering geometry by changing the overall linkage length, using clockwise or counterclockwise rotation of the turnbuckle body to fine tune alignment without swapping parts. The pack contains the turnbuckles plus two lengths of round head screws to suit common mounting depths on the E-Revo steering assembly.

Fitting is straightforward for experienced builders: remove the stock linkage, attach the turnbuckle to the rod ends and knuckles with the supplied screws, then set length by rotating the body until the desired toe/steer is reached. Confirm adequate thread engagement and secure any locknuts or thread-locking solution appropriate for your setup. This product is sold as an aftermarket RC accessory for model tuning and maintenance.