TRAXXAS 4WD GT4 TEC 2.0 Rear Lower Suspension Mount 7pcs GT009 by GPM  [GT009]

Rear lower mount designed for GT4 platforms

This aluminium rear lower suspension mount is an aftermarket replacement designed for the TRAXXAS 4WD GT4 TEC 2.0 platform and supplied by GPM with model code GT009. The component addresses play at the hinge pin area by combining a 6061 T6 aluminium body with POM inserts to keep the lower arm aligned under load, improving predictability during cornering and power transitions.

Construction uses a lightweight high-tensile aluminium alloy for the main mount to resist flex, while the molded POM insert provides controlled compliance and reduces gap at the hinge pin. The design intent is to stabilise the rear lower arm rather than change suspension geometry; tuning effects are subtle and focused on consistency and longevity.

Installation is a direct replacement for the stock rear lower mount on the named chassis. Use the supplied stainless steel flat head screws to secure the mount to the chassis following your normal disassembly steps for the rear suspension. Confirm hinge pin alignment and free movement of the arm after assembly, and re-check screw torque after a short test run.

The kit contains the hardware needed for the swap and small fasteners sized to match the original fixings, allowing installation without additional parts. Typical setup notes: verify hinge pin fit in the POM insert, avoid over-tightening the flat head screws, and check for interference with nearby suspension components before full operation.