TRAXXAS 4WD GT4 TEC 2.0 Aluminum Hex Adapters 7mm Thick GT010/12X7MM by GPM  [GT010/12X7MM]

7mm aluminum hex adapters for GT4 chassis

This aluminum hex adapter set is an RC-scale replacement designed for TRAXXAS 4WD GT4 TEC 2.0 where a precise wheel-to-axle interface is required. The parts are machined from 6061 T6 alloy and specified at a 7mm hex thickness to suit upgraded wheel setups that need a slightly thicker mounting face compared with the original 6.8mm brake disk thickness.

Use these hexes to locate on the axle and transfer wheel loads while keeping concentric alignment for consistent handling and repeatable wheel mounting. The focus is a tight axle fit to help reduce slop that can affect steering response and tyre wear when tuning for track performance.

Hardware included in the kit is supplied for direct replacement or maintenance during setup changes:

• 2x10 steel pin - 4 pcs
• 2x5 stainless steel cap head screw - 4 pcs
• Hex adapters - 12 pcs

Fitment notes: adapter thickness is 7mm, so check clearance against the stock 6.8mm brake disk on your GT4 TEC 2.0 hubs to confirm spacing. These adapters are a tuning item to adjust wheel offset and improve mechanical engagement between the wheel and axle without altering hub geometry.