Team Powers Actinium v3 Motor Modify Rotor 12.3mm x 5mm x 24.1mm Performance Upgrade  [TP-BLR-TP123G-S2]

Price:
CAD$33.88
Brand:
Team Powers
Model:
TP-BLR-TP123G-S2
Condition:
Brand New
Write a review

Tune Your Motor with a Team Powers Actinium v3 Rotor

The Team Powers Brushless Motor Rotor, sized 12.3mm x 5mm x 24.1mm, is engineered to improve the responsiveness of your Actinium v3 motor. It is aimed at hobbyists who want a direct-fit rotor to sharpen throttle feel and overall efficiency.

Noticeable Gains for Actinium v3 Setups

Made to install cleanly into the Actinium v3, this rotor can change torque characteristics and motor response without complex mods. It suits drivers who want measurable differences on both track days and practice runs.

Fitment Notes and Typical Use

With dimensions matched to the Actinium v3 design, this rotor works well for racers and weekend builders who need a precise upgrade path. It is best used where controlled power delivery and reliable performance matter.

Will this rotor drop straight into my Actinium v3 motor?

This rotor is produced to the sizing of the Actinium v3 and should install without machining on motors built to the same spec. Verify your motor's internal spacing before installing.

How will acceleration change after fitting this rotor?

Expect a shift in torque curve and throttle response. The rotor can deliver crisper initial punch and a slightly altered top-end feel depending on your gearing and electronics.

Do I need different bearings or hardware to fit it?

Most users can reuse existing bearings and mounting hardware if they are in good condition. Check bearing fit and shaft clearance during installation for best results.

Copyright © 2008-2025 rcjaz.ca All rights reserved