Team Losi SUPER BAJA REY Servo Mount Kit SB024 by GPM  [SB024]

Aluminum servo mounting kit for Super Baja Rey

This 11pcs aluminum servo mount set is built for Team Losi SUPER BAJA REY fitments and serves as a scale-capable accessory to secure the servo between the main chassis and the sub chassis. The kit pairs a machined aluminum mounting piece with stainless steel fasteners to replace factory hardware and reduce flex at the servo interface.

The primary role of the kit is to stabilise the servo and route steering loads cleanly into the chassis stack. Correct mounting limits unwanted servo movement under load, improving steering consistency and helping the servo retain its trim during hard driving or landings on the Super Baja Rey platform. Manual reference: LOS251059.

Installation notes: align the mount so the screw holes match existing chassis bosses, hand-start screws to confirm fit, and tighten progressively to prevent misalignment. Verify spline engagement and horn orientation before final torque. The aluminum piece will stiffen the mounting area, so check nearby component clearance after fitting.

A straightforward aluminum upgrade to stabilise and reinforce servo installation on the Super Baja Rey chassis, supplied with the stainless fasteners required for a direct swap.