Team Losi SUPER BAJA Aluminum Front Bumper Mount SB330F by GPM  [SB330F]

Stiff 6061 T6 front bumper mount for SUPER BAJA

This 9-piece RC front bumper mount is made for Team Losi SUPER BAJA platforms and is supplied as a complete direct-replacement kit. Machined from 6061 T6 aluminum with added thickness over the stock part, it gives a firmer mounting point to stabilise the front arms and bumper during rough off-road use. The kit includes the aluminium mount plus a matched set of stainless steel fasteners for swapping out the original plastic hardware.

The part is aimed at tuning the chassis rather than cosmetic changes: reducing movement at the bumper-to-arm joint helps the steering remain consistent under load and keeps bumper alignment after knocks. Installation takes the place of the factory bumper mount and uses the supplied screws; note the compatibility warning that this does not fit Losi SBR 2.0, so check your chassis variant before fitting.

Choose this mount when you want a straightforward aluminium swap to reduce front-end flex and keep bumper alignment on rough tracks.