Team Associated RC18T/RC18R Rear Toe Out Mount 0° - RC18-016/BU by 3Racing  [RC18-016/BU]

Aluminum 0 degree rear toe out mount for RC18T and RC18R

This aluminium replacement rear toe out mount is built for Team Associated RC18T and RC18R chassis and holds a fixed 0 degree toe out. The machined aluminum option gives a firmer mounting point than plastic originals and is aimed at drivers who need consistent rear wheel geometry while dialing in suspension settings.

Fitment is specific to RC18T and RC18R rear assemblies; check your vehicle parts list before ordering. The fixed 0 degree position is intended as a neutral rear toe baseline when testing roll, anti-squat and other rear suspension adjustments.

Installation tips: fit the mount into the factory rear mounting points and torque fasteners to recommended values, then confirm wheel alignment with suspension measurement tools. Use this mount as part of a step-by-step tuning routine to compare handling changes with rear toe locked at zero degrees.

Maintenance: inspect the mount and attachment hardware regularly for tightness and wear at mating surfaces. As an aluminum upgrade for RC use, careful handling and periodic checks will help preserve consistent geometry through repeated runs.