RC18T Graphite Battery Plate RC18-021A by 3Racing  [RC18-021A]

Team Associated RC18T Graphite Battery Plate - 3RACING RC18-021A
Price:
CAD$9.78
Brand:
3Racing
Model:
RC18-021A
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

RC18T Graphite Battery Mounting Plate

This graphite battery plate is an RC-scale replacement part intended for Team Associated RC18T chassis installations. Made as an aftermarket hop-up, the plate gives a low-mass, stiff mounting surface that mates with the RC18T battery bay.

Fitting is straightforward on the RC18T layout: the plate uses the chassis original screw positions and hardware. During installation check alignment before final torque, confirm that straps or battery holders sit correctly, and verify clearance to nearby items like the ESC and wiring loom.

From a tuning point of view, graphite adds local stiffness relative to basic plastic trays, which can change how chassis flex influences handling. Fit this plate as part of measured setup changes and run short tests to note any adjustments in traction or steering response.

Can I fit this plate to other 1/18 scale chassis?

The design is aimed at Team Associated RC18T mounting points. If you plan to use it on another chassis, compare screw positions and battery geometry before attempting to fit it.

Will battery size or strap method need changing?

The plate preserves the RC18T battery footprint, but check strap locations and holder clearance; taller packs or alternate holders may require minor repositioning of straps.

Any special care when using graphite parts?

Inspect edges for machining burrs after unpacking, avoid overtorqueing screws to prevent local stress, and keep the plate free of grit that could abrade the pack or wiring.

Copyright © 2008-2026 rcjaz.ca All rights reserved