Team Associated ENDURO SENDERO Front C Hubs Aluminum 5pcs ES019 by GPM  [ES019]

6061 T6 aluminum C-hubs for trail steering

The ES019 aluminum front C-hubs are an RC-scale steering linkage component made for Team Associated ENDURO SENDERO Trail Truck platforms. This 5pcs set replaces the stock plastic C-hubs and includes the hardware needed to secure the hubs to the knuckle arm and gearbox linkage. The part is produced from anodized 6061 T6 aluminum to provide higher tensile strength and abrasion resistance compared with standard plastic pieces.

These C-hubs act as the connection point between the front gearbox and the steering knuckles, helping maintain wheel alignment and steering geometry during aggressive trail use. The metal construction reduces flex under load, helping retain toe and camber settings when running over rocks or rough terrain.

Installation needs basic front-end disassembly to remove the stock hubs, then transfer or replace the wheel hex and mounting hardware. Expect a firmer steering feel after fitting; using matched metal steering links or upgraded knuckles will tighten response further. Use common RC hex drivers to secure the supplied screws evenly and avoid over-tightening.

For builders wanting a metal alternative to stock C-hubs on ENDURO SENDERO Trail Truck kits, the ES019 set offers a direct upgrade focused on consistent steering geometry and longer service life under trail conditions.