Tamiya-compatible Mini 4WD double aluminum rollers 16-17mm - M4WD-35/GO by 3Racing  [M4WD-35/GO]

Tamiya Mini 4WD Double Aluminum Rollers ( 16-17mm )(Golden) - 3RACING M4WD-35/GO
Price:
CAD$10.53
Brand:
3Racing
Model:
M4WD-35/GO
Condition:
Brand New
Write a review

16-17mm double aluminum rollers M4WD-35/GO

These M4WD-35/GO double aluminum rollers serve as a metal replacement for standard plastic rollers on Mini 4WD cars that use Tamiya-style roller mounts. The set uses an aluminum double-roller layout with a golden anodized surface, intended for builders who prefer a harder roller contact surface over the stock plastic pieces.

The rollers are designed for chassis setups that accept 16-17mm outer roller diameters. This is a mechanical replacement only, not an electronic or drivetrain upgrade, so confirm mount spacing and shaft diameter before installation. The anodized surface improves resistance to surface wear, but inspect each part for machining marks or burrs prior to fitting.

What exact size is M4WD-35/GO rated for?

The listing specifies a 16-17mm outer roller range; measure the available clearance on your chassis to ensure the outer diameter will not contact bodywork or rails.

Do these rollers include bearings or bushings?

The product is sold as aluminum rollers only. Bearings, spacers, and fixing hardware are not guaranteed, so check the seller listing for the confirmed contents before purchase.

Which chassis types commonly accept these rollers?

These rollers fit Tamiya-style mounts and are commonly used on performance chassis such as MA, MS, and AR that accept 16-17mm rollers. Always verify shaft diameter and mount spacing first.

Will the anodized surface mark track rails?

Anodized aluminum is harder than untreated metal but rail marking depends on rail material and friction. Run a short test and inspect both rollers and rails, and consider using softer rollers where rail marking is a concern.

Any tips before fitting to a tuned Mini 4WD?

Check lateral play and shaft clearance to prevent rubbing. For tuned racers, verify alignment under load and secure fasteners with thread locker if needed to prevent loosening during runs.

Copyright © 2008-2026 rcjaz.ca All rights reserved