Tamiya WT-01N Front Wheel Shaft 12x7mm Hex WTN2021S127 by GPM  [WTN2021S127]

Aftermarket front axle shaft for WT-01N

This aftermarket RC front wheel shaft set is supplied by GPM for use on Tamiya WT-01N chassis. The shafts are spring steel and are supplied as a 1pr set with a 12x7mm hex adapter included in the package name, intended as a direct replacement or hop-up for scale monster truck front hubs using the WT-01N layout.

Choose this part when you want a stiffer, more wear resistant shaft compared with common stock components. The spring steel construction resists routine running stresses on the front wheel assembly while the 12x7mm hex adapter provides the mechanical interface between shaft and wheel hex. Note this is an accessory for scale RC models only.

Installation notes: confirm wheel hex orientation and tighten fasteners to the torque ranges given in your chassis manual, check wheel runout after fitting, and inspect for play at bearings and hub interfaces. Regular cleaning and wear checks will extend service life both on track and off-road.