TAMIYA WR-02/DT-03T/Blitzer Beetle Aluminum Front Upright Set (Gun Metal) - JR-WR201-GU by Jazrider  [JR-WR201-GU]

Tamiya WR02/DT03T/Blitzer Beetle Aluminum Front Upright Set (Gun Metal)
Price:
CAD$12.93
Brand:
JAZRIDER
Model:
JR-WR201-GU
Condition:
Brand New
Available in shop
Write a review

Robust aluminum uprights for WR-02 and DT-03T use

This JR-WR201-GU aluminum front upright set is an aftermarket replacement made for use with TAMIYA WR-02, DT-03T and Blitzer Beetle chassis as stated in the product name. The parts are CNC machined aluminum with a gun metal finish and replace the factory plastic uprights to give a firmer mounting for the front hub and steering linkages.

Installation uses the original WR-02/DT-03T mounting points and the same hardware locations, so stock screws and pins will normally be reused. After fitting, recheck steering geometry and wheel alignment because a stiffer upright can alter toe and camber behavior under load.

Approach this as a measured tuning upgrade: confirm fit with your existing knuckles, wheel hexes, and bearings, and bench-test before running. The JR-WR201-GU is aimed at scale suspension tuning and improved durability without changing drivetrain layout.

How do these uprights mount to WR-02 and DT-03T frames?

They mount to the same points used by the stock plastic uprights on WR-02 and DT-03T. You will normally reuse the original screws and pins; check that the fit is snug and re-tighten after a short test run.

Will I need different wheel hardware to fit these uprights?

In many cases the existing wheel hexes and bearings will fit, but confirm compatibility with your wheel hex size and inner bearing width before installation to avoid surprises.

What are these uprights made from and what finish do they have?

The uprights are machined from aluminum and finished in gun metal as specified in the product title. This provides greater stiffness and a scale metal look compared with the original plastic parts.

Copyright © 2008-2026 rcjaz.ca All rights reserved