TAMIYA WR02/DT03T Front Upright Aluminum Upgrade - JR-WR201-LB by Jazrider  [JR-WR201-LB]

Tamiya WR02/DT03T/Blitzer Beetle Aluminum Front Upright Set (Light Blue)
Price:
CAD$12.71
Brand:
JAZRIDER
Model:
JR-WR201-LB
Condition:
Brand New
Available in shop
Write a review

Light-blue aluminum uprights for WR02 and DT03T

This aluminum front upright kit is made for TAMIYA WR02, DT03T and Blitzer Beetle chassis. The light-blue anodized finish identifies the metal upgrade while keeping the original mounting geometry, and parts are supplied as matched left and right uprights.

Use this set when you want a firmer, more repeatable steering pivot than stock plastic. In typical tuning workflows the uprights act as a rigid mount for steering links and front suspension parts, helping to hold toe and camber under load and making setup adjustments more consistent between runs.

Installation tips: the uprights are machined to match standard mounting locations on WR02/DT03T/Blitzer Beetle front assemblies, so replacement generally uses the existing suspension pins and hardware. After fitting, confirm free steering movement and full suspension travel to ensure no binding.

Can I swap these uprights onto my WR02 front end without drilling or trimming?

They are manufactured to the factory mounting points for WR02, DT03T and Blitzer Beetle front assemblies, so you should see a direct swap. Always test fit before running to confirm alignment and clearance.

Will I need different pins or bearings to install these uprights?

No special hardware is included; plan to reuse compatible pins and bearings from the original upright assembly if they are in good condition. Replace worn parts for best performance.

What practical handling change should I expect after fitting metal uprights?

Expect reduced flex at the steering pivot compared with plastic parts, which helps maintain toe and camber under cornering load and produces more predictable steering behavior during repeated runs.

Copyright © 2008-2026 rcjaz.ca All rights reserved