TAMIYA WR02/DT03T Blitzer Beetle Aluminum Front Upright Upgrade for Improved Steering - JR-WR201-GR by JAZRIDER  [JR-WR201-GR]

Tamiya WR02/DT03T/Blitzer Beetle Aluminum Front Upright Set (Green)
Price:
CAD$12.93
Brand:
JAZRIDER
Model:
JR-WR201-GR
Condition:
Brand New
Available in shop
Write a review

Aluminum uprights tuned for steering precision on TAMIYA models

This aluminum front upright set is an RC-scale replacement part intended for use on TAMIYA WR02, DT03T and Blitzer Beetle chassis as indicated by the product name. Manufactured and finished in green, the uprights serve as a direct-type steering/knuckle assembly alternative to typical plastic pieces, offering greater rigidity for consistent steering geometry under load.

Installation notes: this kit replaces the front upright assemblies and mounts to existing steering links and hubs on compatible TAMIYA WR02/DT03T/Blitzer Beetle setups. When fitting, confirm thread sizes and hardware compatibility with your chassis, tighten fasteners progressively to avoid misalignment, and check steering free-play before running.

Tuning role: aluminium uprights are used to reduce flex at the steering spindle, which helps maintain consistent toe and camber behavior during cornering and when running on rough surfaces. They are typically selected by drivers who want a firmer steering response and improved repeatability for setup adjustments.

How will these uprights change steering feel on track?

Aluminium uprights reduce component flex at the spindle, so steering tends to feel firmer and more consistent. Expect a more predictable response through corners and recheck toe and camber settings after installation to fine tune handling.

Do JR-WR201-GR uprights fit WR02 and DT03T without extra hardware?

They mount to the same steering links and hubs as the original uprights, but you should verify thread pitch and retained hardware. If your chassis uses aftermarket hubs or long-drive adapters, check for clearance before final assembly.

What maintenance do aluminium uprights need?

Periodically inspect mounting fasteners and contact surfaces, keep threads clean, and avoid over-tightening which can bind steering. Replace any worn hardware to preserve fit and geometry consistency.

Copyright © 2008-2026 rcjaz.ca All rights reserved