This aluminum steering assembly is an RC-scale replacement for the Tamiya TT02 and TT02B touring chassis. It swaps the factory plastic steering pieces for metal components to increase stiffness at the link pick-up points, reduce flex under load, and deliver a sharper steering response during tight turns and directional inputs.
Installation centers on replacing the stock steering parts without changing servo end points. Basic fitting needs standard hex drivers and careful attention to steering geometry; tighten fasteners to proper thread engagement and confirm neutral toe and Ackermann before you run the car. The part is compatible with typical 1/10 scale touring setups and works with standard servo sizes used on TT02 platforms.
Tuning note: fit this aluminum assembly when you want firmer mechanical feedback for more precise steering or as a base for upgrading servo horns and reinforced drag links. It does not alter electronic settings but gives a more consistent mechanical platform for setup changes.
Copyright © 2008-2026 rcjaz.ca All rights reserved
