Tamiya TT02B Rear Upper Tie Rod Upgrade, Spring Steel Centre TT2B057P by GPM  [TT2B057P]

Tamiya TT02B Spring Steel Rear Upper Tie Rod With Plastic Ends - 1pr - GPM TT2B057P
Price:
CAD$8.15
Brand:
GPM
Model:
TT2B057P
GTIN:
4894538217773
Condition:
Brand New
Write a review

Rear upper link for TT02B tuning

This aftermarket rear upper tie rod is built for the Tamiya TT02B chassis, featuring a spring steel centre section with plastic ball ends that fit the factory suspension link points while keeping weight low.

Installation is a direct swap: remove the stock tie rod and fit this unit into the same rear bulkhead and suspension mount locations. After installing, confirm rear toe and check that the suspension cycles freely; small toe changes are made by rotating the adjustable centre section if your TT02B uses a turnbuckle style link.

Compared with full-plastic rods, the spring steel centre adds stiffness to help maintain rear toe under braking and cornering, making it a useful upgrade when dialing in balance on 1/10 touring car setups.

Does this mount to the original TT02B rear upper points?

Yes. The part is designed to install at the same rear upper attachment points used by the stock TT02B tie rod.

What tools are required to fit it?

Basic hex drivers and pliers for the ball ends are sufficient; no special hardware is needed for standard TT02B installations.

Will this affect rear feel on track?

Expect a firmer rear response and more consistent toe under load, which can be fine tuned with toe settings and spring rates.

Copyright © 2008-2026 rcjaz.ca All rights reserved