Tamiya TT01/TT01E Rear Lower Aluminum Arms - JR-TT107-BK by Jazrider  [JR-TT107-BK]

Tamiya TT01 / TT01E Aluminum Rear Lower Suspension Arms (Black)
Price:
CAD$14.04
Brand:
JAZRIDER
Model:
JR-TT107-BK
Condition:
Brand New
Available in shop
Write a review

Aluminum Rear Lower Arms

This RC-scale rear lower suspension arm set fits the Tamiya TT01 and TT01E chassis, supplied in black and listed as model JR-TT107-BK. The arm replaces the stock plastic rear lower arms with an aluminum unit that mounts to the same rear suspension points on the chassis.

Fit these when you want a firmer rear linkage to improve rear-end feel and setup consistency. Installed arms affect wheelbase alignment and pivot geometry, so they are most effective when used together with shock and toe adjustments to refine handling. These parts are intended for RC use only.

Installation notes: remove the original rear lower arms and fit the aluminum units to the same mounting locations, using the existing screws and hardware from the chassis where applicable. Basic hand tools and a hex driver are sufficient for installation; check pivot pin play and linkage routing after fitting to confirm free movement of the suspension.

Are these arms compatible with both TT01 and TT01E?

Yes. The listing specifies compatibility with TT01 and TT01E models, so these arms are designed to replace the stock rear lower arms on those chassis variants.

Will I need extra hardware to install them?

In most cases the original screws and pivot pins can be reused. We recommend a hex driver and an inspection of existing fasteners for wear before reuse.

What handling change should I expect after fitting aluminum arms?

Aluminum lower arms increase stiffness at the linkage, making rear response more consistent during setup changes. To get the best balance, tune shocks and toe settings in conjunction with these arms.

Copyright © 2008-2026 rcjaz.ca All rights reserved