TAMIYA TT01E/TT01ED Aluminum Steering Set - JR-TT103-LB by Jazrider  [JR-TT103-LB]

Rigid aluminum steering upgrade for TT01E/ED

The JR-TT103-LB aluminum steering set provides a metal replacement for the stock steering components on Tamiya TT01E and TT01ED chassis. The kit is built to improve durability while maintaining a direct interface with the existing steering linkage, preserving the original steering geometry as plastic parts are swapped for anodized aluminum.

The light blue anodized finish helps parts stand out visually and adds a layer of corrosion resistance over raw metal, while the aluminum parts reduce unwanted flex in steering linkages under load. This kit is made for 1/10 scale electric touring RC cars and is intended to work with the standard servo link connections and steering mounts used on TT01E/TT01ED setups.

Installation overview: remove the stock plastic steering pieces, keep any reusable fasteners and bearings, then position the aluminum components into the same mounting points. Verify linkage alignment and servo horn fit before final tightening to ensure neutral toe and correct steering centring. No specialty tools beyond common hex drivers for TT01 maintenance are required.

Swap in this steering set to replace worn plastic components and achieve a firmer steering interface for setup, maintenance, and on-track consistency with TT01E/TT01ED 1/10 touring builds.