Tamiya TT-01 Rear Aluminum Hub Carrier 2 Degree - TT01-12/2/LB by 3Racing  [TT01-12/2/LB]

Aluminum rear hub carrier for TT-01 setups

This machined aluminum rear hub carrier is a scale replacement made for Tamiya TT-01 and TT-01 TYPE E chassis. The unit fixes the rear hub angle at 2 degrees to help refine rear toe and roll characteristics on electric touring and scale models.

The carrier offers greater dimensional stability than molded plastic stock parts thanks to its machined aluminum construction, and it mounts in the same rear location used by the original hub carrier on compatible TT-01 layouts. Fit this part when you need a predictable metal baseline for setup comparisons or to replace worn plastic components.

Installation notes: the part replaces the stock rear hub carrier and uses the factory mounting points on TT-01 and TT-01 TYPE E rear suspension assemblies. After installation, check wheel alignment and rear toe, and verify there is no interference throughout full suspension travel. This item is intended as an aftermarket setup component for handling adjustments.

Fitment details

Compatible with Tamiya TT-01 and TT-01 TYPE E chassis when used as an aftermarket replacement.