TAMIYA TT-01 Rear Aluminum Hub Carrier 1 Degree - TT01-12/1/LB by 3Racing  [TT01-12/1/LB]

Aluminum rear hub carrier for TT-01 chassis

This rear hub carrier is made to suit TAMIYA TT-01 and TT-01 TYPE E touring car chassis, providing a 1 degree rear offset so you can alter toe geometry without replacing suspension arms. As an aluminum replacement it gives a stiffer, more reliable mounting point for the rear wheel hubs and helps maintain consistent toe under load during club or track use.

Check that your chassis hub layout matches the TT-01 variants listed before ordering, as compatibility is limited to those models. The aluminium construction improves stiffness compared with stock plastic carriers and reduces unwanted toe change from impacts and heavy cornering.

Fitment follows the standard hub carrier swap for the TT-01 family using the original wheel spindle and fasteners. After installation verify wheel bearing alignment and suspension geometry; a 1 degree offset produces subtle changes to mid-corner balance and may need small toe trims to tune handling back to your preferred setup.