Tamiya TRF421X Graphite 2.25 Main Chassis Upgrade - O-TCP009 by Factory Pro  [FP-O-TCP009]

Factory Pro FP-O-TCP009 Tamiya TRF421X - Main Chassis - Graphite 2.25
Price:
CAD$64.15
Brand:
Factory Pro
Model:
FP-O-TCP009
Condition:
Brand New
Write a review

Chassis Overview and Fitment

The Factory Pro O-TCP009 is an aftermarket graphite main chassis designed for the Tamiya TRF421X platform. It provides a direct-fit 2.25 graphite plate intended as a like-for-like replacement for the TRF421X main chassis, using the same mounting interfaces required by that chassis layout.

Built for chassis tuning, the graphite main chassis changes flex and on-track feedback when you alter setup. When fitting this plate, confirm hole alignment with your TRF421X hardware and reuse original mounting hardware where recommended. Also verify clearance around the motor mount, gearbox, and bulkheads before final assembly.

Specifications

  • Item Main Chassis
  • Material Graphite
  • Model Number O-TCP009
  • Compatibility Tamiya TRF421X
  • Size 2.25

Use the Factory Pro graphite main chassis O-TCP009 when you need a direct replacement for TRF421X setups or when adjusting chassis balance and flex is part of your tuning approach; confirm fitment and torque settings during installation to preserve alignment and drivetrain operation.

Will this chassis mount directly to stock TRF421X components?

The plate is produced to match TRF421X mounting points; however, verify hole alignment and recheck clearances with your motor mount and gearbox before final assembly to avoid interference.

What tools and torque specs should I use for installation?

Use the hex drivers specified for your TRF421X and follow the torque recommendations in the original manual. Inspect hardware for proper thread engagement and avoid overtightening the graphite plate.

How will graphite affect handling compared to stock material?

Graphite typically alters chassis flex and feedback versus composite plates; expect changes in turn-in and mid-corner balance that can be tuned with suspension and roll center adjustments.

Do I need any extra parts to fit this chassis?

No additional parts are listed; reuse your TRF421X standoffs, screws, and bearings if they are in good condition and compatible with the graphite plate.

What maintenance does a graphite chassis require?

Inspect for surface cracks after impacts, keep mounting surfaces clean, and avoid overtightening fasteners which can cause stress fractures in graphite.

Can this chassis be used on other TRF models?

This part is specified for the TRF421X. Confirm compatibility with other TRF variants before attempting installation, as mounting details may differ between models.

Copyright © 2008-2026 rcjaz.ca All rights reserved