Tamiya TRF 416 Foam Front Bumper 416-17 by 3Racing  [416-17]

Front foam bumper for TRF 416

The 416-17 foam bumper is made as a direct replacement for the Tamiya TRF 416 chassis, formed from resilient foam to absorb light impacts and protect the front end without changing chassis geometry.

Fitting is straightforward: remove the worn foam and secure the replacement to the TRF 416 front mounting points. It uses the stock bumper bracket so extra hop-ups are not required, but check mounting tabs for alignment before final fitment. Routine removal and replacement are normal maintenance after contact or wear.

For setup the bumper acts as a protective sacrificial element rather than a tuning device; it cushions contact and reduces small impact forces but does not serve as a suspension tune, though it can affect how shock loads transmit into the chassis during a run.

Fitment notes

Manufactured as a foam replacement for the Tamiya TRF 416 front bumper, matching the original part geometry for straightforward swap-in installation.