Tamiya TRF 416 Differential Bearing Housing Upgrade 416-10D by 3Racing  [416-10D]

Upgraded diff housing for TRF 416

This RC differential bearing housing is a direct-fit hop-up made to replace the original housing on Tamiya TRF 416 assemblies and mounts in the factory location for straightforward swap-in installation.

Installation follows normal differential service: remove the diff from the chassis, open the diff case, replace the housing component, then reassemble while confirming correct bearing seating and alignment. Keep the original screw positions and the TRF 416 torque recommendations during reassembly.

During setup, the housing helps keep diff bearings and gears aligned under load; consistent seating and correct clearances reduce premature wear and preserve predictable diff response during acceleration and cornering in 1/10 racing setups.