TAMIYA TL-01/GF-01/WR-02 Rear Hub Carrier, Aluminum Red - TL01-13305-RD by Jazrider  [TL01-13305-RD]

Machined aluminum rear hub for TAMIYA platforms

This machined aluminum rear hub carrier is a replacement component intended for use with TAMIYA TL-01, GF-01 and WR-02 chassis. The part is anodized red and serves as the rear wheel mounting and suspension attachment point on compatible TAMIYA layouts. The following notes cover fitment, installation tips, and practical tuning advice.

Fit and role: The carrier locates the wheel hub and provides the mounting surfaces for suspension links and axle hardware. Use it as a direct replacement when your chassis' mounting pattern and bearing bores match the TL-01, GF-01, or WR-02 designs. Always confirm hole spacing and bore sizes on your chassis before fitting.

Installation notes: Remove the rear wheel and unbolt the original carrier following your chassis service steps. Typical tools include metric hex drivers and small wrenches for wheel nuts and link hardware. Fit bearings and axle hardware from the chassis or donor pieces; the carrier is supplied as the structural component and may not include bearings or extra fasteners unless the seller states otherwise.

Tuning and maintenance: When upgrading to an aluminum carrier, monitor mounting screw torque to avoid stressing threads in plastic or composite bulkheads. If you change suspension geometry with this carrier, make incremental adjustments and check static toe and camber under wheel load. Periodically inspect fasteners and bearings as part of routine maintenance.