TAMIYA TL-01/GF-01/WR02 Aluminum C Hub, Red - TL01-13306-RD by Jazrider  [TL01-13306-RD]

Aluminum C hub for TAMIYA front uprights

This is an RC-scale aluminum C hub intended as a direct replacement for the listed TAMIYA chassis lines. It matches the TL-01, GF-01 and WR02 mounting interfaces shown in the product title and is offered in a red finish to visually match tuned onroad builds.

As a metal C hub, the component replaces the factory plastic part to reduce deformation under load and to provide a firmer steering pivot point. That role is useful when tuning steering responsiveness and predictability without altering servo or suspension hardware.

Installation follows standard C hub replacement practice: remove the wheel and steering knuckle, transfer any bearings or inserts, fit the aluminum C hub to the upright using the original fasteners, and verify steering geometry before testing. No special tools beyond common hobby hex drivers are required for the swap, and care should be taken to maintain original fastener torque and alignment.

The part is presented as an RC accessory for maintenance or incremental tuning; it is not a performance cure and should be integrated into setup changes step by step while checking toe and camber after installation.