This JR-TL106-BK C-hub set is an aluminium steering component made for RC-scale Tamiya TL-01, GF-01, and WR02 chassis. The black anodized finish provides a metal alternative to the stock plastic hubs and is intended for owners looking for a firmer steering pivot and longer wear life in standard hobby use.
Functionally the C-hub locates the front wheel carrier and defines a portion of the steering geometry. Replacing the stock hubs with aluminium units changes the feel at the steering tie-rods and can support repeated teardown and reassembly without the deformation that affects some plastics over time. The part is described as compatible only with the TL-01, GF-01, and WR02 platforms; do not assume fitment on other chassis.
Installation notes: the set is intended to interface with the original mounting points on the listed Tamiya chassis and the existing front carriers and wheel axles. Check fastener engagement and steering linkage alignment after fitting to confirm free movement through the full suspension travel. When used in tuning, aluminium C-hubs are typically chosen to stabilise steering geometry under repeated loads rather than to change baseline suspension kinematics.
Copyright © 2008-2026 rcjaz.ca All rights reserved
