This RC wheel hub adapter is sold as 2pcs with a gun metal finish, made from machined aluminum and designed specifically for Tamiya Thunder Shot, Thunder Dragon, Fire Dragon and Terra Scorcher models. The aftermarket adapter fits between the wheel hex and the axle mounting face to correct wheel fitment and improve repeatability during setups.
Use these adapters when you need to alter wheel clearance or standardize wheel seating after fitting different rims or tyres. This hop-up is aimed at improving wheel alignment and repeatable seating rather than altering suspension geometry or drivetrain behavior.
Installation is simple for hobbyists: remove the wheel, replace the factory spacer or hub adapter with the supplied aluminum piece, then reinstall and tighten the wheel using the vehicle's existing fasteners. No special machining is normally required, but always verify thread engagement and wheel clearance before running the car.
Materials and pack details are as stated: aluminum construction, gun metal finish, 2pcs per set, for RC use. Model JR-TFD11-GU identifies this specific adapter set.
Copyright © 2008-2026 rcjaz.ca All rights reserved
