This 1/10-scale aluminum wheel hub adapter fits Tamiya Thunder shot, Thunder Dragon, Fire Dragon and Terra Scorcher chassis. Supplied as two red pieces, the part replaces the plastic mounting interface to provide a metal contact surface for repeatable wheel fitment and setup.
Fit and function: the adapter installs as the direct wheel hub interface on the listed Tamiya models, helping secure consistent wheel seating and reduce looseness that can occur with worn plastic hubs. It is intended as a chassis-level hop-up for improved wheel alignment and handling rather than a drivetrain component.
Installation notes: remove the wheel and original hub per your chassis manual, position the adapter onto the axle or hex stub as required by your hub type, fasten with the existing wheel nuts or screws, then verify wheel runout and free rotation before a test run. Re-check fasteners after an initial short run.
Tuning role: use the adapter when changing wheel types, experimenting with offsets, or when a stable metal mating surface is needed for consistent wheel alignment and bearing seating during setup work on Tamiya buggy builds.
Copyright © 2008-2026 rcjaz.ca All rights reserved
