This pair of front and rear lower suspension arms is made as a direct replacement for TAMIYA Thunder Shot, Thunder Dragon, Fire Dragon and Terra Scorcher buggies. Supplied as 2 pcs in a gun metal finish, the parts are intended to refresh worn plastic arms or to convert to metal components for increased durability and a firmer feel.
Fitment is specific to the chassis names shown and intended for use on 1/10 scale TAMIYA buggy platforms only. Installation follows the same basic steps as the original lower arms: remove the wheel, detach the hub carrier or linkage as required, replace the lower arm and secure with the existing hardware. Always check geometry and wheel alignment after fitting before running.
From a tuning standpoint, aluminum lower arms alter component stiffness and long-term wear compared with factory plastic arms. Expect a modest change in response and a trade-off between greater solidity and slightly different feedback through the suspension; adjust shocks and toe/camber to dial back your preferred handling balance.
Choose these arms when you want a sturdy aluminum replacement that retains the original mounting points and supports straightforward tuning adjustments on the listed TAMIYA buggy chassis.
Copyright © 2008-2026 rcjaz.ca All rights reserved
