This aluminum front stabilizer holder is a direct-fit accessory for TAMIYA Thunder Dragon and Thunder Shot models, designed to replace the stock plastic mount with a firmer metal option. It anchors the front stabilizer bar and reduces flex at the mounting points, producing a more predictable change in front roll behavior during tuning.
Installation follows the factory mounting pattern on the front bulkhead and uses the existing stabilizer rod ends. Remove the plastic holder, align the JR-TSD01-RD holder to the factory holes, and secure with the original screws and hardware. Cycle the suspension and steering through full travel before final torque to confirm clearance.
When tuning, this aluminum mount increases the effectiveness of small stabilizer changes by keeping the anchor rigid, delivering crisper roll feedback across repeated laps. Fit this part when you want quicker front-end reaction or when upgrading shocks or steering components.
Service tip: periodically check fastener tension and inspect mating faces for wear. Aluminum cuts down on mount flex but can transfer loads to adjacent plastic parts, so check surrounding components after fitting.
Copyright © 2008-2026 rcjaz.ca All rights reserved
