Tamiya Thunder Dragon / Thunder Shot Aluminum Front Stabilizer Holder - JR-TSD01-BK by Jazrider  [JR-TSD01-BK]

Tamiya Thunder Dragon/ Thunder Shot Aluminum Front Stabilizer Holder (Black)
Price:
CAD$13.91
Brand:
JAZRIDER
Model:
JR-TSD01-BK
Condition:
Brand New
Available in shop
Write a review

Front anti-roll mount overview

This aluminum front stabilizer holder is an RC spare part for Tamiya Thunder Dragon and Thunder Shot buggies. It functions as the mounting point for the front stabilizer and is intended to refine front-end roll behavior during cornering and transitional weight transfer.

The machined aluminum provides a firmer mounting surface than typical plastic holders, enabling crisper sway bar response and more precise tuning of roll resistance and balance when changing sway bar rates or testing suspension settings. It is supplied as an aftermarket replacement compatible with the Tamiya chassis names shown in the title.

Installation usually replaces the factory stabilizer holder and retains existing linkage and hardware when compatible, making it useful for on-track tuning sessions. As with any metal hop-up, inspect mating surfaces and fasteners for secure fitment before running.

How will this holder change front roll on the track?

Expect a firmer connection point for the sway bar, which reduces unwanted flex and produces a more consistent roll response. That lets you tune sway bar stiffness and suspension settings with finer resolution for cornering performance.

Should I alter sway bar settings after fitment?

Yes. Because the holder reduces flex, you may need to soften or stiffen sway bar rates to reach the same roll balance you had with the stock mount. Run controlled tests and adjust incrementally.

Any installation tips for best results?

Verify alignment of existing linkage and reuse compatible hardware where applicable. Torque screws evenly and check that mating surfaces seat flush to avoid binding during runs.

Copyright © 2008-2026 rcjaz.ca All rights reserved