Tamiya TA07/TB04 Pro II Rear Aluminum Suspension Arms - JR-TA707-GU by Jazrider  [JR-TA707-GU]

Gun Metal Rear Suspension Arms

This aluminum rear suspension arm set is a direct-fit RC-scale replacement for Tamiya TA07 and TB04 Pro II chassis, supplied in a gun metal finish for a low-profile look. The component is intended for hobby use on 1/10-scale touring rigs and focuses on chassis durability and predictable suspension response.

Construction is aluminum, which alters flex characteristics compared with standard plastic arms and helps maintain geometry under load. These arms are used in tuning to influence rear roll stiffness, camber recovery and overall rear-end consistency when adjusting spring rates or anti-roll settings.

Installation notes: swap the arms into the existing rear suspension pick points on the TA07/TB04 Pro II, retain original hardware and ball studs unless replacements are specified by your kit, and check clearances with the motor, gearbox and servo travel after fitting. Inspect for proper thread engagement and recheck all fasteners after the first running session.