This aluminum rear upright hub carrier is designed for the TAMIYA TA07 chassis and is offered as model JR-TA703-GU. The component is machined from aluminum and finished in gun metal to replace the plastic stock carrier for builders who want to refine rear steering geometry and extend part life on 1/10 touring models.
Installation uses standard wheel hub hardware and requires alignment to the TA07 suspension pick-up points; no special tools beyond common hex drivers are normally needed. The carrier is intended to mate with existing wheel axles, bearings, and suspension links without chassis modification, while adjustments to roll center and toe can be explored through wheel placement and linkage tuning.
Use this carrier as a setup and tuning item rather than a guaranteed lap-time upgrade, since it provides a firmer mounting point for rear hubs that can help stabilize steering response during track or club runs.
Copyright © 2008-2026 rcjaz.ca All rights reserved
