Tamiya TA07 Rear Upright Hub Carriers Aluminum Upgrade - JR-TA703-BK by Jazrider  [JR-TA703-BK]

Aluminum upright carriers for TA07 chassis

This aluminum rear upright hub carrier is an RC-scale replacement part made for the Tamiya TA07 chassis. It replaces the stock upright with a firmer aluminum mounting point to deliver more consistent rear wheel location and improved repeatability in suspension behavior.

Installation requires removing the rear hub assembly and fitting the aluminum carrier using the vehicle's existing hardware. Verify bearing seating, axle retention, and clearance so the suspension can achieve full travel without interference prior to running.

From a setup perspective, this carrier helps stabilise the wheel hub attachment and gives a consistent reference for toe, camber, and roll center adjustments. After swapping to aluminum, re-check rear geometry and minor setup items to maintain the handling balance you expect.

Notes: Supplied as a mechanical spare for the TA07 chassis only. This is a non-electrical replacement part; compatibility outside TA07 is not specified.