This aluminum front suspension mount set is an RC-scale upgrade designed for use with the TAMIYA TA07 chassis and is finished in gun metal. It replaces the stock mounting points to provide a firmer attachment for the front suspension tower, which influences steering response and suspension articulation while you tune the car.
Installation is straightforward for builders familiar with TA07 maintenance: remove the original front mount, transfer any reusable fasteners and bearings, install the aluminum mount using the existing screw locations, and check chassis alignment before a shakedown run. Standard hex drivers are sufficient, but confirm screw lengths and thread engagement to avoid undue stress on the chassis.
On the bench this mount helps the front end keep consistent camber and caster under load, making small geometry adjustments more repeatable. Adopt incremental setup changes and short trial runs to verify the handling you want before full sessions.
Copyright © 2008-2026 rcjaz.ca All rights reserved
