Tamiya TA05/TT-01 Type-E/DF-03 12mm Wheel Adaptor +1 Offset TA05-12/1/RE by 3Racing  [TA05-12/1/RE]

12mm aluminum wheel adaptors for Tamiya chassis

This pack contains four 12mm wheel adaptors in anodized light blue made for RC work on Tamiya chassis. Each adaptor gives a +1 offset to adjust track width and wheel position without changing the hub or wheel face. Machined from aluminum, the parts are supplied as direct-fit accessories for compatible Tamiya models.

Compatibility is limited to hubs and wheels that use a 12mm hex. Install by fitting the adaptor between the wheel and hub so the wheel mounts to the adaptor's 12mm interface; check your wheel hex size and hub clearance before installation. Standard TA05, TT-01 TYPE-E and DF-03 setups that accept 12mm adaptors normally need no extra machining.

In setup terms the +1 offset gives a small, repeatable change to track width and scrub radius to fine-tune handling and tyre wear. Fit the adaptors across all four corners for consistent handling changes or to resolve minor clearance issues with aftermarket wheels.