TA05 Rear Hub Carrier Aluminium 3 Degree - TA05-16/3/LB by 3Racing  [TA05-16/3/LB]

Lightweight aluminium rear hub carrier for TA05

This aluminium rear hub carrier is made for the Tamiya TA05 chassis with a fixed 3 degree rear inclination. Finished in light blue anodize, it replaces the stock plastic carrier to provide a firmer mounting for the rear hub and suspension pickup. It is intended for fine chassis tuning where small hub geometry changes influence camber recovery and roll response.

Installation is straightforward for those familiar with TA05 service: remove the original carrier and fit this unit using the existing hardware and bearings. Standard hex drivers and sockets used on TA05 models are sufficient. After installation, inspect rear camber and toe and torque the hub mounting screws to the recommended value for aluminium components to protect threads.

As a tuning accessory, expect increased rear stiffness and clearer feedback in cornering which can change how load moves across the rear tyres under throttle and direction changes. Intended for hobby and track use on 1/10 scale TA05 touring cars only.