Tamiya TA-02T Aluminium Rear Knuckle Pair for touring cars - TA2T022 by GPM  [TA2T022]

Machined aluminium rear knuckles for TA-02T handling

This pair of rear knuckle arms is offered as an aluminium alternative to the stock plastic parts used on the TA-02T platform. Machined to the original mounting layout, the components aim to cut deflection in the rear steering links for a more direct steering feel and repeatable response when you change setups.

Installation is a bolt-on swap with the TA-02T rear hubs and existing hardware. Confirm bearing fit and screw lengths, check that suspension travel is unobstructed, and apply correct torque for small RC fasteners. Because these are metal parts, recheck mating surfaces and fastener torque after initial runs and following any impacts.

Setup effect: swapping plastic for aluminium increases stiffness in the rear steering assembly, which can make adjustments to toe, camber, and rear suspension settings show clearer handling differences. Fit these as part of a measured tuning approach for on-road or touring layouts.

A straightforward aluminium upgrade for TA-02T owners wanting reduced rear steering flex and a firmer base for tuning without modifying the chassis.